Forum: Pit Crew

Yes I know.....but who better than the banned to start it :blush: So....what did everyone do to theirs today?? I just went on a fun little...

A tip for a cleaner oil change. Once you have your crank case and frame plugs out, try removing the main oil galley plug under the oil filter housing...

Okay well so far this is only occurring when the throttle is wide open. It feels like the engine hesitates for a moment then suddenly revs hard then...

For those of you with 10,000 or more miles and you have been running the stock cam chain tensioner I have some advice for ya. I have the top-end...

How well does the Vapor work on your bikes? How are the hook-ups and connections holding up? I have its little brother ( Endurance ) on my quads....

So back to basics... first of all, which way is the crush washer suppose to go ? http://i287.photobucket.com/albums/ll155/micknwop8/0515001345.jpg...

Ok, don't laugh.:blush: I am used to washing my MX, dump some Castrol "degreaser" on it, rub and spray it down with the pressure washer, grease it...

first of all, sorry if this is in the wrong section i wasnt sure where to put it.... i was just doing some thinking and wondering while im waiting...

Went to the Suzuki dealer this arvo as everyone seems to say get the stock brake pads as they are very good, so I just said my model and this what...

Hi all, just wondering if anyone else has had problems with surface rust on thier Z? I have had it appearing in certain areas over the past couple...

My header got real rusty. Seeing how people got amazing results polishing their stainless steel MRD pipes, I wanted to try the same and ordered...

Figured I would start a Handgaurd thread. I went to a local bike dealer, they generally have a nice offroad section. They had cycra hand gaurds...

I took my Harley in to the dyno this afternoon, expecting to tweak the carb a bit. To our surprise, neither of us wanted to touch a thing! Apparently...

http://www.drzforums.com/showthread.php?t=124&page=33 I figured at this point its worth its own thread. Pulled the bike apart today. Pulled...

You know, the one you take when you ride? :o One didn't come with the bike, so its on my list of things to do. The Dual Star kit seems like a...

I am trying to find some new graphics that would go with the white... I kinda like this one ha ha, ...

So this is a long shot, but I will ask. First off just recognizing that I am a dumbass. I took off the front fender to remove the reflectors and...

Anyone know of a good dirt or off road tire to switch over to on my drz 400 im getting terrible traction off pavement right now with the distanzia's...

If there's one thing that seems rather common about motorcyclists, it's the desire to make each bike his own. Some riders are content with adding a...

Alright, i know there are tons of little tricks to spruce these bikes up and i need one to do today cause i'm bored! Already removed cannister. Is...

I remember reading articles in the past about going through the break in period with standard oil and then after a certain amount of miles it is ok...

Anyone know good shop (ideally in the north end) for anodizing parts?

So yeah, I'm dumb. I should have installed the rad guard I have sitting in my garage. I crashed the other day in the forest and deformed the...

:eek: So, I am finally medically cleared to take the 2004 DRZ-S I bought in August out for a real ride. :) Bike has stock carb, which I just...